Model Number

DY

Cone Crusher is widely used in some trades like metallurgy, building materials, road building, chemicals and silicate industry. Taper crusher is applicable for various ores and rocks of medium break hardness or above. Taper crusher has strong break force, high efficiency, large process quantity, low operation cost, easy adjustment and economical application. For it has reasonable parts materials and structural design, it has long service life and even break granularity to reduce circulation load. For the middle and large crushers, hydraulic pressure chamber-cleaning system is adopted to reduce the stop time. And the chamber type of different crushers can be ed by users according to their demand. Taper crusher is sealed with lubricate grease to avoid the block of water supply and drainage system and the mixing of water and oil. Spring insurance system is overload protection device to make extraneous substances and iron pieces pass breaking chamber not to damage crusher. Trapper crusher includes standard type and short-end type. Generally, the standard type works for large feed grains and discharged grains are rough and the short-end type has steep break wimble and works for small feed grains and produce of fine materials. So the standard type is always used for rough and medium materials break and the short-end for medium and fine materials break.
Working Principle of Cone Crusher:
Cone crusher crushes materials by the working surface between the movable cone and fixed cone. So it is more advanced and efficiency than jaw crusher. The movable cone is supported by spherical bearing and fixed on an hanging erect shaft which is set in the eccentric sleeve, and the sleeve is set on the stopping and pushing bearing. The movable cone and erect shaft are drived by the eccentric shaft sleeve together. The eccentric shaft sleeve is driven by horizontal shaft and fimbriated gear, and the wheel of the conveyor belt is drived by motor through v-belts.The lower part of vertical shaft is installed in the eccentric sleeve. When the eccentric sleeve rotates, there is a conical surface lined out by the shaft. When the movable cone comes near the fixed cone, rocks are grinded into pieces, when the cone leaves, grinded materials is discharged the diacharge

If you want to know more information,please send inquiry to
brickmachineChina at yahoo doc com  deyimachine at hotmail doc com  skype:brickequipment